DIN7h8 Unhardened Dowel Pins

DIN7h8 Metric Unhardened Dowels are produced with an 'h8' push fit tolerance in both Mild Steel and Stainless Steel. Our standard metric diameter range is from 0.8mm up to 20mm diameter and lengths 3mm to 120mm are available. This range of unhardened pins is produced from material 1.0718 Mild Steel or 1.4305 (A2) Stainless Steel.

Please note that the nominal length of a DIN7h8 pin is measured along the parallel surface only, the chamfers at each end of the pin are not calculated as part of the nominal length.

Diametrical tolerance 'h8' limits are further explained in the chart below.

Diameter Range Tolerance Band (h8)
From 0 to 3mm +0.000 / -0.014mm
From 3 to 6mm +0.000 / -0.018mm
From 6 to 10mm +0.000 / -0.022mm
From 10 to 18mm +0.000 / -0.027mm
From 18 to 30mm +0.000 / -0.033mm

If you require unhardened mild steel or stainless steel push fit tolerance pins which are measured overall please refer to our specification S01 or L01.

If you require interference fit pins to be measured overall please refer to our specifications R01 (unhardended steel) or K01/F01 (stainless).

Pinco series N01 (Mild Steel) and E01 (Stainless Steel), for further detailed information please contact us.